TA+P2I
User Manual
Release r06 www.stollmann.de Page 6 of 18
The installation of your TA+P2I is done in a few simple steps:
• Connect the power supply to the TA+P2I and mains: The green LED “READY” at
the front panel will be lit.
Attention: Please use only the delivered power supply!
• Connect „LINE 1“ with the first analogue line of the cable modem, LINE 2 with
the second one. The corresponding LEDs LINE1 and LINE2 will be lit green.
• Connect the ISDN phone(s) to one or both ISDN plugs. As an alternative you
can connect the previous installed ISDN cabling to one of the ISDN plugs.
Note: The ISDN terminating resistors for the ISDN network are integrated
inside the TA+P2I already.
• Check whether you can receive calls using all called numbers. If you have
problems please proceed as follows:
o If one ISDN phone shall react on all incoming calls from both lines it is
necessary to delete all still activated MSN settings inside the ISDN
phone.
o If one ISDN phone shall react only to the phone numbers of one of the
analogue lines of the cable modem, change the former MSN settings and
use the digit “1” as MSN for that phone, which shall react on incoming
call from line 1. Please handle the same way for the ISDN phone that
shall be allocated to line 2, this phone needs the digit “2” as MSN setting.
o Example:
For line 1 was associated the call number 123123123 and for line
2 the call number 456456456
If an ISDN phone shall only accept incoming calls for the number
123123123, set up the MSN of this phone to „1“.
If another phone shall react on incoming calls to 456456456,. set
up the MSN of this phone to „2“.
If a third phone shall react on all incoming calls, so delete all
MSNs of that phone.
• More information you can find in your phone manual. If you have problems
setting up MSNs please contact your dealer or the manufacturer of the phone.
More setups you will find in the next chapter.
To Next Page
Loading...