Stone Bake Primo - Oven Delivery and Movement; Oven Assembly Steps

© The Stone Bake Oven Company 2011. All rights reserved. © The Stone Bake Oven Company 2011. All rights reserved.
2.2 Oven delivery
The Primo Oven is easy to assemble and arrives in an inclusive crate:
- The Oven dome, weighing approx 70kg.
- The Oven base, two parts, approx 45kg each.
2.3 Oven assembly
Step 1
Select position in outdoor space in which to place the oven, ensuring that:
- The base is level
- You adhere to oven clearances (see Oven clearances section 2.1)
- You are away from strong winds and drafts.
Step 2
If applicable construct the Primo stand with the instructions included or
alternatively if you are constructing your own customized base for your Primo
Oven, The Stone Bake Oven Company strongly advise that you lay the ovens
base on a solid noncombustible foundation covering the entire surface area of
the ovens footprint. If you decide to lay your own base, you must ensure that it
is capable of supporting a weight of at least 200kg.
Step 3
NOTE: ENSURE OVEN BASE IS FACING THE CORRECT WAY BEFORE SET
DOWN.
We recommend that anyone lifting the oven is adequately trained in lifting
techniques. Ensure all ngers and clothing are kept clear from beneath the
oven base and between oven dome and base joint.
NOTE: Oven dome and base is fragile handle with extreme care when moving
to prevent slight chipping.
Carefully place the oven base in two parts on your level pre-constructed base
or framework, lay the front of the ovens base rst, followed by the rear of the
ovens base which slots onto the front, as shown.
Tongue and groove base Two parts t together
To form the base Carefully place the dome in place
WARNING!
Oven assembly and movement require a minimum
of 4 adults to reduce the risk of bodily injury and
oven damage. The oven weighs approx 160 kg, in a
total of three pieces. Take care during construction.