- 25 -
3. OPERATION
Bulldog
®
the operator switches. The remote functions
are disabled.
2. The radio remote on/off switch must be in
the on position to operate in remote.
3. If the on button located on the transmitter
is used to start the machine, all control of the
machine is accomplished at the transmitter.
The manual functions are disabled.
4. The emergency stop button can be used to
shut off the machine in either manual or
remote operation.
3.3 BEFORE STARTING
Review the following information. Specific
information regarding these items can be found in the
Technical Data Section # 3 or located from the Table
of Contents.
3.3.1 Warnings
Fuel is highly flammable, handle with care. Do not
refuel the engine while smoking or when near an
open flame or sparks. Always stop engine before
refueling. Clean up spilled fuel before starting.
Avoid fires by keeping engine clean of accumulated
grease and debris.
Diesel fuel stored in galvanized containers reacts
chemically with the zinc coating on the container.
The chemical reaction creates powdery flakes of zinc
sulfide. If water is present in the fuel, a zinc
hydroxide gel will form.
Do not run unit in an enclosed, unventilated area.
Avoid prolonged breathing of exhaust gases.
3.3.2 Pre-Start Checklist
1. Check engine oil level.
2. Check engine air cleaner.
3. Check engine fuel level. Note: Always use
clean diesel fuel to prevent damage to the
fuel injection components.
4. Check hydraulic fluid level.
5. Check hardware for looseness. If loose,
tighten according to torque chart.
6. Check hoses for looseness or leaking.
7. Visually check safety devices:
E-Stop Button - check that button is
not damaged and that it moves
properly.
Anti-Crush Bar - check that bar
switch and actuation components are
not damaged and that all parts move
and work properly.
3.4 STARTING THE MACHINE
This machine can be started two different ways
dependent upon the mode of operation.
3.4.1 Manual Mode (Item 1, Section 1.5)
Starting of the machine is accomplished by inserting
the key and turning the keyswitch clockwise to the
start position. After engine catches, release the key
to the run position. At this time all switches on the
operator control panel are operational. The engine
will run at idle speed. All transmitter/radio functions
are disabled.
Notes: The radio remote on/off switch should be in
the off position. The radio remote on/off switch is
located on the operator control panel.
3.4.2 Activating The Remote Control System
1. Turn radio remote switch to the on position
(located on the operator control panel, see Section
1.5, Item 9).
3.4.3 Remote Mode (Items 1 & 2, Sections 1.5 &
1.6)
Starting the machine is accomplished by pressing the
To Next Page
Loading...
