- 29 -
3. OPERATION
Bulldog
®
circuit causing the machine to stop moving in
reverse. The engine will remain running. Move the
machine directional controls to forward motion to
clear any entrapment.
3.12.3 Inspection
Always inspect that this device is attached and
operating properly. Visually inspect bar, linkage,
springs and switch. Test circuit with machine
operating to ensure that it is working properly.
3.13 OPERATION ON SLOPES
Never operate the machine in violation of tip angle.
Refer to Technical Section for tip angle and
gradeability. Running the machine in excess of tip
angle will cause machine to be unstable. The result
could be operator injury, engine or machine damage.
To Next Page
Loading...
