- 42 -
6. MAINTENANCE
Bulldog
®
6.12 BATTERY POLICY
Battery warranty begins when a roller is sold from
Stone Construction Equipment, Inc. or a Stone dealer
to a customer.
Battery warranty claims must include the unit's
purchase receipt with date. Claims without purchase
receipt will be based on the battery identification
numbers.
Battery returns and/or adjustments are made through
battery distributors.
For nearest Exide distributor call:
1-800-782-7848.
Parts Master warranty: 50 month, 12 month free
replacement. Thereafter, replacements will be based
on an adjustment.
6.13 ECCENTRIC HOUSING OIL
The eccentric housing oil should be changed after
500 hours usage or yearly.
Danger of scalding from hot
oil. Trap the old oil and dispose of it in accordance
with local legislation.
The fill plug is located in the center of the housing
cap. The drain plug is located on the bottom of the
housing cap (opposite side from the fill cap).
To drain, remove the drain plug and remove the fill
plug. Allow the oil to drain out completely. Replace
the drain plug. Refer to the Lubrication
Specifications Section for proper oil and quantity.
Replace fill plug.
6.14 VALVE-TAPPET CLEARANCE
Check every 250 hours.
6.15 FUEL INJECTORS
Check and clean fuel injectors every 250 hours.
We recommend that you consult a HATZ SERVICE
STATION or a specialist workshop for repair and
adjusting operations to the injector.
Keep your hands away from the injector jets. The
jet produced by a functioning injector can cause
blood poisoning.
6.16 COOLING FINS - ENGINE
Clean dirt or debris from air intake. Clean engine
cooling fins daily and more frequently when
operating in dusty conditions.
6.17 HARDWARE/HOSES
Due to the nature of vibration equipment,
periodically check all hardware and hoses for
tightness.
6.18 TRANSMITTER BATTERY
New batteries received from Stone Construction
Equipment, Inc. should be charged.
To set the battery life between charging, run the
battery until it no longer works the first time you use
it.
If battery replacement is required, remove four (4)
screws from back of transmitter. Transmitter requires
two (2) AA Alkaline Batteries.
For Remote Transmitter battery information, see
section.
6.19 CLEANING MACHINE
When cleaning machine, caution should be used
around regulator area of the engine. Excessive water
pressure may loosen worn terminals or start terminals
corroding. After each cleaning, these terminals
should be dried and connections should be checked
for proper seating. Failure to do so could cause
future regulator failure or other electrical problems.
WARNING
To Next Page
Loading...
