Store It Cold CoolBot PRO - Page 16

Rev: 2018 – 7A ©2018 Store It Cold, LLC 15
System States
These are the possible states for the system as a whole, from the app’s point of view:
Light-shaded display texts (gold and salmon) indicate situations that might (gold) or do (salmon) need the user’s
attention.
Dark-shaded display texts (raspberry) indicate that we know for sure the cooler is not performing as desired.
Display text
Notes
User actions
All hardware OK
None
Starting up
Wait
Thermostat disabled
On user request
Turn Power On/ Off at
Device - Settings Tab
Updating firmware
Update time is normally less than one minute
Wait
Weak Wi-Fi signal
Move radio module or Wi-Fi
access point
Connecting
Provisioning or initial connection is completed, but we haven’t
heard from the device yet. Typically flashes too briefly to see;
if it shows for longer, could indicate a server or device issue.
Wait
Disconnected from server
E.g., timed out
Try reconnecting
Room temp briefly high
Temp is over the high threshold but the device hasn’t flagged
it for notification yet (takes 30 minutes consistently above, min.
60 minutes since last notification)
Check A/C, room, etc. - or
wait to see how long it
persists
Room temp briefly low
Same, but under the low threshold
Check A/C, room, etc. - or
wait to see how long it
persists
Room temp was high
Temp is under the high threshold now, but the device is still
waiting to clear the notification (takes 30 minutes or a fall of 3
°F)
Check A/C, room, etc. - or
wait to see how long it
persists
Room temp was low
Same, but now above the low threshold
Check A/C, room, etc. - or
wait to see how long it
persists
CoolBot briefly offline
Device is disconnected, but for less than 30 minutes
Check A/C, room, etc. - or
wait to see how long it
persists