Storz OR1 SmartScreen - Page 22

Electromagnetic compatibility
Instructions for use • OR1 SmartScreen • PQJ219_EN_V1.0_04-2021_IFU_CE-MDR 22
8.6 Table 4 – Emission class and group
Guidelines and manufacturer’s declaration – electromagnetic emissions
The device is intended for use in such an environment as specified below. The customer or
user of the device should ensure that it is used in such an environment.
Interference emission measure-
ments
Compliance Electromagnetic environment –
guidelines
RF emissions acc. to CISPR 11 Group 1 The device uses RF energy only for
its internal function. Therefore, its
RF emissions are very low and are
not likely to cause any interference
in nearby electronic equipment.
RF emissions acc. to CISPR 11 ClassA The device is suitable for use in all
establishments other than domestic
and those directly connected to the
public low voltage power supply
network that supplies buildings
used for domestic purposes.
Emission of harmonic oscillations
acc. to IEC61000-3-2
ClassA
Voltage fluctuations/flicker emis-
sions acc. to IEC 61000-3-3
Complies