To Next PageTo Next Page
Need help?Do you have a question about the strapex STB 70 and is the answer not in the manual?
Read operating instructions carefully before using the tool.
Battery-operated hand tool for plastic strapping, model STB 70.
Instructions for charging the battery.
Instructions for inserting the battery into the tool.
Initial steps for operating the tool.
Details of the tool's operating panel and indicators.
Understanding the battery charge indicator LEDs.
How to select and use different operation modes.
Adjusting the strap tension force for optimal results.
Adjusting the duration of the welding process.
How to check the quality of the welded seal.
Statement of conformity with EU directives and applied standards.
Weight, dimensions, tension, speed, and sealing specifications.
Details on the battery charger, battery, and charging times.
Details on strap quality, width, and thickness.
Explains CAUTION, WARNING, and NOTE symbols and their meanings.
Guidelines for environmentally sound disposal of the tool and its parts.
Key safety advice including reading instructions, protecting oneself, and power source safety.
Warnings about strap snapping, breaking, crushing, and proper usage.
Guidance on water avoidance, using original spare parts, and intended use.
Overview of the tool's physical components and layout.
Detailed explanation of the control panel buttons, LEDs, and display.
How the tool functions to tension, weld, and cut straps.
Step-by-step guide to charging the tool's battery.
Initial steps for using the tool, including inserting the battery and positioning the strap.
Detailed steps for tensioning the strap and performing the weld/cut.
What to do after welding, including audible signals and seal verification.
Recommendations for cleaning the tool during regular use.
How to visually inspect the quality of the welded seal.
Interpreting the LED indicators for battery charge levels.
Adjusting the strap tension force using the control panel.
Configuring the soft tension setting for specific strap types.
Adjusting the duration for the welding cycle.
Selecting between Semi-Automatic, Fully-Automatic, and Manual modes.
Instructions for adjusting the tool for different strap widths.
How to lock and unlock the control panel to prevent accidental changes.
How the tool enters sleep mode to save battery power.
Steps to perform a device reset if the rocker lever is blocked.
Procedures for cleaning and replacing the tension wheel.
Procedures for cleaning and replacing the tooth plate.
Steps for replacing the cutting knife.
Explains common error codes E11 to E37 and their remedies.
List of parts subject to wear and recommended spare parts.
Comprehensive list of all parts with part numbers and quantities.
Contact details for Strapex representatives worldwide.
General