Theme Plus Issue 2.1 28/06/01 Page 9 of 12
Instruct the user
1. Hand over these Installation Instructions and the User Instructions to the person who
is going to use the fire and explain how to light and operate the appliance. Explain
how the fire may be lit, if necessary, by means of a long spill or taper.
2. Make certain that the user is aware that the ceramic blocks and coals must be
located in accordance with the instructions, and that the appliance should be
serviced at regular intervals by a competent person to ensure continued safe
operation.
3. Explain that this appliance is fitted with an oxygen depletion sensor incorporated into
the pilot body. Should the fire repeatedly extinguish itself, the cause should be
sought and remedied as this may indicate spillage into the room of combustion
products.
4. Indicate the tie-on warning label, which the customer must remove and read.
5. Advise the user that any smell given off by the appliance will clear away after a little
use.
6. Point out that these instructions must be retained in a safe place for future use.
Maintenance
Servicing should be carried out regularly by a competent person in accordance with these
instructions and the relevant regulations, to ensure the safe and correct operation of the
appliance.
At least once a year check for debris in the flueway. If soot has accumulated ensure that the
chimney is swept clean.
Before commencing any service or replacement of parts, turn off the main gas supply and
ensure that the fire is cold.
When ordering spare parts please quote appliance serial number which can be found on the
data badge plate.
Ceramics
Examine the coals and ceramic blocks for signs of cracking and replace if necessary. Handle
the ceramic components with care. Dust off any soot or deposits with a soft brush. Do not
vacuum clean.
Removal of burner & convection box
1. Turn off the gas supply by the isolation cock.
2. Disconnect the 8mm pipe from the elbow at the left-hand side of the burner.
3. Remove the flat trim, box trim, or optional canopy trim.
4. Remove the 2 screws holding the burner to the convection box and lift the burner out
of the opening.
5. Remove the 4 screws in the flange of the convection box, and lift the box out of the
opening.
6. Examine the flue for debris and clean if necessary.
7. Reassemble in the reverse order.
8. After servicing check for gas soundness.
Following a service, a check should be made for clearance of combustion products. Follow the
procedure detailed in these instructions.
Cleaning the fire
Black paint: Use only a clean damp cloth. Do not use any cleaning agents.
Brass parts: Use Brasso or Duraglit ensuring that it does not come into contact with the black
paint finish.
IMPORTANT - The paint finish is durable and heat resistant, however it will be damaged if
plaster, cement or wallpaper paste is allowed to come into contact with it. Protect the
appliance during re-building or decorating work.
To Next Page
Loading...