Stream HYDROBOX 900 - Product Description; Product Overview; Model Description; Performance Parameters

2 PRODUCT DESCR IPTION
Failure to observe safety cautions may pose a risk to persons or property and
invalidate the product warranty.
1.4.1 When the product is powered on, the controller will resetautomatically and restart
the function. Please take safety protection measures to the corresponding
equipment in advance.
1.4.2 It is strictly forbidden to disassemble the cover while the product is running,
otherwise it may cause electric shock.
1.4.3 The product should be set according to the operation steps in the manual when
debugging. If it is not operated properly, the product may be damaged. The
parameters preset when the product leaves the factory have met most of the pump
operating requirements. If not necessary, do not modify the control parameters
randomly.Otherwise, it may cause equipment damage.
1.4 Debugging
Not like traditional water pumps, HYDROBOX 900 is featured with home appliance
design, ultra-silence, easy control, simple installation, intelligent constant pressure
control, and widely used in home and villa water supply pressurization.
- Applying Permanent magnet motor, wide voltage, 85% motor efficiency
- Frequency inverter control, frequency up to 60HZ, effective noise control
- Global Top design, exquisite appearance, compact structure, easy operation
- "TWO" control modes: automatic and manual mode
- Built-in soundproof cotton, reduce noise effectively
- Intelligent control system, comprehensive automatic protection, reliable use
2.1 Product Overview
1.5.1 If the product is damaged, it must be replaced by the manufacturer or its
authorized technical support service to avoid any risk.
1.5.2 Wait for at least 5 minutes after power failure and observe that the indicator lights
are completely off before performing maintenance and inspection, otherwise it may
cause electric shock.
1.5.3 Do not pull the cable and remove the plug from the socket.
1.5 Maintenance and inspection
2 3
Electrical parameters
Power supply：1~ 160-250V/50HZ~60HZ
Input Power：900W
Output Power：0.66KW
2.2 Model Description
2.3 Performance Parameters
2.4 Performance Curve
HYDROBOX900
Input Motor Power（W）
All-in-one Structure Intelligent Pump
60
50
40
30
20
10
0
0 10 20 30 40 50 60 70 80 90
Q(L/min)
H(m)
Materials
Pump body: Plastic MPPO
Impeller: Plastic MPPO
Machine seal: ceramic / graphite
Shaft: Stainless steel
Bearing: NSK
Motor housing: aluminum alloy
Pressure tank: stainless steel diaphragm tank
Sensor: Pressure type
Performance parameter
Maximum head: 50m
Maximum flow: 5.2m³/ h
DNA:1 "G
DNM: 1 "G
Maximum pressure: 6bar
Protection level: IP54