Lisa LCD 5
Connecting the USB service cable
The USB connection is used for service purposes, which include programming your device, software
update, and monitoring of the communication between the Lisa and the internet. The B-connector of the
USB cable is plugged in the device, while the A-connector is intended for connection to your Windows
PC. Before making this connection we recommend that the Lisa Configuration Tool is first installed.
3
Using the Lisa
3.1 Device configuration
The Lisa LCD starts up with the so-called configuration wizard, which asks the user to enter the most
important configuration settings, such as menu language, IP settings etc.
The other configuration settings on the Lisa may not be what is needed for your specific application, or
they may have to be updated during use. Therefore the Lisa retrieve its configuration from a remote
location (provisioning platform) via the network connection.
The Lisa devices can be used in combination with a range of configuration and distribution platforms
(Streamit Device portal, Streamit Audio Distribution Platform (ADP), or a custom-built platform). The
most common configurations settings (e.g. list of presets) can be changed on the platform side and get
communicated to the device when this performs a configuration update (e.g., during startup).
By default a Lisa device is programmed to use the Streamit Device portal as configuration platform.
The configuration platform does not allow you to change the IP settings. These can be changed using the
on-board menu or the Lisa Configuration Tool.
3.2 Switching on the Lisa for the first time
The first time the Lisa LCD is powered on, it will start in the configuration wizard mode.
1. The configuration wizard will ask the user for the most important configuration settings. Enter the
correct information during the configuration wizard, especially with regard to IP settings. The Lisa
requires valid IP settings to be able to connect to the provisioning platform, software update server and
activation server. For networks employing a proxy, you must use the Lisa Configuration Tool (LCT) to
configure the correct proxy details.
2. After the configuration wizard is complete, the device will try to connect to the default provisioning
platform (Streamit Device portal) . Shortly after that, it will look whether a new version of the software
is available and update if required.
3. Register and assign the correct configurations for this device in the chosen provisioning platform. The
default provisioning platform is the Streamit Device portal. When a different provisioning platform must
be used, please use LCT to configure the correct platform location.
To Next Page
Loading...
