other connectors intended for such use. Be sure that your installation is fused.
The striped power lead is positive and the unmarked lead is negative. When connecting
the charger to a fuse block, the striped, positive power lead goes to the connector that is
dead when the vehicle’s fuse is removed. The charger body is electrically isolated from the
charge circuit and allows positive ground installations. The charger is polarity protected,
and if connected in reverse polarity, simply won’t operate until connected properly.
Streamlight recommends connecting chargers to an unswitched source of power to ensure
the flashlight is always fully charged. If the vehicle will not be driven for several days, the
flashlight should be removed from the charger to avoid vehicle battery drain. Charging
the flashlight with the USB charger will draw between .4 -.6 amperes for up to 3 hours
during charging. Charging the flashlight and spare battery with the USB Piggyback charger
will draw between .5 - .7 amperes for up to 6 hours. Either charger will draw less than .1
amperes when in maintenance mode when battery(s) is fully charged.
BATTERY REPLACEMENT
Unscrew the tailcap and slide the battery from the flashlight. Replace the battery by
inserting the contact end first and reattach the tailcap.
MAINTENANCE
•Keep all threads and o-rings lubed with silicon grease.
• Keep tailcap to barrel connection clean. Loose or dirty tailcap will
cause the flashlight to malfunction.
• Keep flashlight charger contacts clean at all times. Poor contact can cause charger
malfunction. An abrasive pencil eraser works well to clean the contacts.
REPLACEMENT PART(S)
BATTERY P/N 74175
IMPORTANT – Be sure to use genuine Streamlight
®
replacement parts.
Learn more about work lights on our website.
To Previous Page
Loading...
