strex SP280 - General Device Safety

56
GENERAL DEVICE SAFETY
● Do not use the Projector for any other purpose other than its intended use (see the chapter
“INTENDED USE”).
● The Projector is designed and intended for private use (at home and in the oce) and is not
suitable for commercial purposes.
● The Projector is intended for indoor use only. Do not use the device outdoors.
● Handle the device carefully. Jolts, impacts, or a fall even from a low height can damage the
device. Always avoid shaking.
● Do not place the Projector on any unstable surface. This may result in falling and cause
malfunction.
● Do not place the Projector under mechanical stress.
● The device needs to be properly and securely installed and mounted. Follow the instructions to
prevent any possible damage/injury.
● The device needs to be properly and securely connected. Follow the instructions to prevent any
possible damage/injury.
● Never use accessories not recommended by the manufacturer. They can pose a danger to the
user and damage the device.
● Never drop or insert any object or ngers into any opening.
● Do not apply excessive force when using the buttons on the Projector or the remote control.
● Do not leave the switched-on Projector unattended. Close supervision is necessary when used
near small children.
● Do not use the Projector near strong magnetic elds, e.g. motors, transformers, mobile phones,
etc.
● If it is no longer possible to operate the Projector safely, take it out of operation and protect it
from any accidental use. A safe operation can no longer be guaranteed if the device:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in poor ambient conditions or
- has been subjected to serious transport-related stresses.