59
HEAT & COOLING
● The Projector may become warm during operation. This is normal.
● To avoid overheating, turn o the Projector after 4 hours of continuous work, and turn o the
power for 30 minutes before turning it on again.
● Do not cover the device or the ventilation holes while it is in operation as this may cause the
Projector to overheat. This poses a risk of re, electric shock, or injury.
● Do not cover the device with anything when it is still hot. This poses a risk of re.
● Make sure that the ventilation around the device is good. Always leave a minimum distance of 10
cm around the device to ensure sucient ventilation.
● Do not place any objects in front of the lens while the Projector is operating. Doing so could
cause a re.
● Do not cover the lens with the supplied lens cap while the Projector is on. Doing so can lead to
the melting of the cap and possibly burning your hands due to the heat emitted from the light
output.
● When the Projector is in operation, you may sense some heated air and odor from its ventilation
grill. It is a normal operation and not a defect.
● Keep the device away from heat sources and away from areas where the ambient temperature is
relatively high (e.g. stoves or other heat sources). Never use the device near naked ames (such
as burning candles) or on hot surfaces.
● The device should not be used on surfaces such as carpet and plastic or near any heat-sensitive
object.
● The Projector is designed to work best in normal ambient temperatures between 0°C and 35°C
and to be stored at temperatures between 0°C and 45°C. The Projector may be damaged and
the battery life of the remote control may be shortened if the device is stored or used outside
this temperature range. Do not subject your device to dramatic changes in temperature. Do not
store your device in a hot car or direct sunlight for extended periods. Do not place the device
near a window (especially in the summer).
● Use the device only in a moderate climate (not in a tropical climate).
To Next Page
Loading...
