strex SP280 - How to Use

44
WARNING:
● You are required to make sure the mounting is performed rmly
and stably. If mounted on a mount or a tripod, make sure that the
mount/tripod will hold the weight of the Projector and any additional
attachments. If mounted upside down, pay special attention to safety
and make sure the mounts and used screws are rm and secure.
Incorrect Installation.
The image is smaller on
the right.
Incorrect Installation.
The image is smaller on
the left.
Correct Installation.
The image is
rectangular.
HOW TO USE
1. Connect to mains power:
Connect the plug power cord with the Projector and connect the plug of the power cord to a
mains outlet.
2. Power on:
Press the ON/OFF button on the control panel or remote control to turn on the Projector.
3. Adjust the trapezoid distortion:
After starting up the Projector, follow the gure below to adjust the trapezoid distortion. Keep
the Projector vertical with the Projector screen and keep it on the same level.