12
BATTERY & FUSE REPLACEMENT
If “ “ appars on display, it indicates that the battery should be replaced. Fuses rarely needs
replacement and blow almost always as a result of operator’s error.
To replace battery & fuse (200mAI250V) remove the 2 screws in the bottom of the case. Simply
remove the old, and replace with a new one.
Be careful to observe battery polatity.
ACCESSORIES
● Operator’s instruction manual
● Set of test leads
● Gift box
● 9 Volt battery.
WARNING
Before attempting to open the case, always be sure that test leads have
been disconnected from measurement circuits.
Close case and tighten screws completely before using the meter to avoid
electrical shock hazard.
To Next Page
Loading...
