SAFETY INFORMATION
SAFETY SYMBOLS
MAINTENANCE
This multi meter has been designed according to IEC -1010 concerning electronic measuring
instruments with an overvoltage category (CAT n) and pollution 2.
Follow all safety and operating instructions to ensure that the meter is used safely and is kept in
good operating condition.
Full complianca with safety standards can be guaranteed only with test leads supplied. If necessary,
they must be replaced with the type specied in this manual.
Important safety information, refer to the operating manual.
Dangerous voltage may be present .
Earth ground.
Double insulation (protection class II).
Fuse must be replaced with rating specied in the manual.
4
● Before opening the case, always disconnect test leads from all energized circuits.
● For continue protection against re: replace fuse only with the specied voltage and current
ratings : F 200mA/250V(Ouick Acting)
● Never use the meter unless the back cover is in place and fastened completely.
● Do not use abrasives or solvents on the meter. To clean It using a damp cloth and mild detergent
only.
To Next Page
Loading...
