GENERAL DESCRIPTION
The meter is a handheld 31/2 digital multimeter for measuring DC and AC voltage, DC current,
Resistance, Diode and Transisto. This multimeter is powered by a 9V battery (included)
DURING USE
● Never exceed the protection limit values indicated in specications for each range of
measurement
● When the meter is linked to measurement circuit, do not touch unused terminals.
● Never use the meter to measure voltages that might exceed 600V above earth ground in
category II installations.
● When the value sclae to be measured is unknown beforehand, set the range selector at the
highest position .
● Before rotating the range selector to change functions , disconnect test leads from the circuit
under test.
● When carrying out measurements on TV or switching power circuits always remember that there
may be high amplitude voltages pulses at test points. which can damage the meter.
● Always be careful when working with voltages above 60V de or 30V ac rms . Keep ngers behind
the probe barriers while measuring.
● Before attempting to insert transistors for testing. always be sure that test leads have been
disconnected from any measurement circuits.
● Components should not be connected to the hFE socket when making voltage measurements
with test leads.
● Never perform resistance measurements on live circuits.
5
To Next Page
Loading...
