12
OPERATION
TO OPERATE POWER BUTTON - ON AND OFF
NOTE:
The StrikeMaster Lithium 24v is powered using the Lithium Ion 24v Battery (Model# LTV-B/LTV-BCA)
supplied with the unit.
1. Make sure your footing is secure and that you have the unit in the vertical position firmly in your hands.
2. Place Directional Control Switch in Forward position.
3. Pull up the operating lock lever (deadman’s switch) , then press the POWER button .
The auger will start drilling.
4. To stop the auger, release the POWER button and the operating lock lever.
5. In the event your auger gets stuck during operation, reposition your feet and place Directional Control Switch to
Reverse position. This should release spiral from obstruction.
6. When the auger is not in use, remove the Battery.
NOTE:
If you are planning to use the Battery multiple times in a single outing, it is ideal to remove the battery and
place in a warm location. This is especially important in cold weather conditions.
W A R N I N G
Keep the operating lock lever and POWER button pressed while using the ice auger.
FORWARD/REVERSE
1. Depress the direction control switch to the forward side. The auger will rotate clockwise.
2. Depress the direction control switch to the reverse side. The auger will rotate counter-clockwise.
3. The unit must come to a complete stop to change direction.
W A R N I N G
KEEP POWERHEAD CLEAR OF WATER.
FORWARD/ REVERSE NOTE: Forward/ Reverse
position needs to be selected when the spiral is
at rest. The auger spiral will maintain its current
direction until it comes to a complete rest.
Example: While drilling a hole in the forward position
if switch is accidentally engaged into reverse during
drill cycle, the spiral will continue in forward until the
power buttons are released and the spiral comes to a
complete stop.
3
3
2
1
1
2
To Next Page
Loading...