Labotom-3
Instruction Manual
1. Getting Started
In the packing crate you should find the following parts:
1 Fork spanner 24mm, for changing the cut-off wheel
1 Inlet hose, 13mm dia., 2m
1 Outlet hose, 50mm dia., 2m
4 Hose clamps
1 Elbow pipe, 90°
1 Elbow pipe, 45°
1 Drain pipe
1 Set of Instruction Manuals
Use a 13 mm socket spanner to remove the screws underneath
the pallet.
Labotom-3 should be placed on an optional Struers table unit, or
other suitable table. Ensure that the table is level.
The table should be able to carry a weight of min. 100 kg. The depth
should be at least 750 mm. Generally, the best working position will
be achieved using a table 800 mm high or lower.
Make sure there is enough room behind the table for the inlet and
outlet hoses and for the protection guard to be opened fully.
Checking the Contents
Note: Placing Labotom-3 on a table unit
Lead the electric cable, inlet and outlet hose through the opening
in the back of the table.
To Next Page
