Strymon MultiSwitch Plus - Custom Mode Operation

MultiSwitch Plus - Extended Control
pg 5
Custom Mode
Release the footswitch. The LEDs on
MultiSwitch Plus will flash GREEN when
configuration is complete. All three
outputs carry the same signal in this mode.
Enter Custom Mode by holding down the C
footswitch while connecting the TRS cable to
MultiSwitch Plus. The C LED will flash RED
to confirm the selection.
Connect the included TRS cable to the EXP
jack of the pedal you wish to control.
3
2
1
This mode adds remote control functionality unique to the supported pedal.
1
Check the manual for the connected
pedal for for specific functionality and
instructions on how to configure the pedal
for use in this mode.
4
A B
C
+
EXP
1
Check the Compatibility Chart on pg.15 for details
and a list of compatible pedals.