Strymon MultiSwitch Plus User Manual

MultiSwitch Plus - Extended Control
pg 8
Footswitches A / B and output jacks 1 / 2 match the behavior of Preset mode. Footswitch C
and output jack 3 match the behavior of TAP, FAV, BOOST & SPEED MODE.
Combo Mode
After entering Combo Mode the C footswitch
LED will indicate whether it is assigned to
control Tap (GREEN LED) or FAV/Boost/Speed
(RED LED). Press the C footswitch to toggle
between these two options.
Enter Combo Mode by holding down the A and
B footswitches while connecting the TRS cable
to MultiSwitch Plus. The A and B LEDs will flash
RED to confirm the selection.
Connect the included TRS cable from output 1
or 2 to the appropriate jack of one of the pedals
you wish to control.
Press and hold B to exit configuration.
Connect an additional TRS cable from output 3
to the pedal receiving Tap, Boost, Fav or Speed
signal.
Check the Appendix for instructions on how to
configure the connected pedal for use in this
mode.
3
2
1
4
5
6
PRESET 1
PRESET Output Footswitch C
Output Signal
PRESET 2 Tap, Boost,
Fav or Speed
Check the Compatibility Chart on pg.15 for details
and a list of compatible pedals.
A
B C
A
B
C
+ +
EXP

Strymon MultiSwitch Plus Specifications

General

Brand	Strymon
Model	MultiSwitch Plus
Category	Control Unit
Language	English