Stuart Turner Showermate S2.6 bar Single

Questions and Answers

M
morganphillipAug 9, 2025
How to troubleshoot a Stuart Turner Water Pump that will not start?
- R
  Raymond LittleAug 9, 2025
  If your Stuart Turner Water Pump won't start, several factors could be at play. First, ensure there's sufficient gravity flow by checking that the flow rate is at least 0.8 l/min on both hot and cold settings. Then, verify the power supply and check the fuse. Also, make sure the circuit breaker is properly set. If the motor is buzzing, immediately switch off the power and contact Stuart Turner. Finally, allow the thermotrip to auto-reset, confirming the duty point and run time are within the specified limits.
M
Melissa BushAug 14, 2025
What to do if Stuart Turner Water Pump runs on with outlets closed?
- L
  lopezrachelAug 14, 2025
  If your Stuart Turner Water Pump runs continuously even when all outlets are closed, the issue might be a jammed flow switch. Try removing the outlet hoses to check if the flow switch sits in its lowest position. A leak in the system could also be the cause, so check tap washers, toilet valve washers, and pipe joints for any leaks. If the pump continues to run, it could indicate a closed circuit in either the flow switch reed or P.C.B. in the terminal box, in which case you should contact Stuart Turner.
A
Aaron HernandezAug 25, 2025
Why is there no hot water with my Stuart Turner Water Pump?
- D
  David PowersAug 25, 2025
  If you're not getting any hot water with your Stuart Turner Water Pump, start by venting the hot water pump to remove any trapped air. Check that your boiler is switched on and functioning correctly. Ensure that the hot water cylinder contains hot water, indicating that it hasn't all been used. If you have a thermostatic mixer valve, consult the manufacturer's instructions to ensure it's working properly.
C
Carly BishopAug 29, 2025
Why does my Stuart Turner Water Pump start with all outlets closed?
- D
  Dana WattsAug 29, 2025
  If your Stuart Turner Water Pump starts when all outlets are closed, it could be due to air in the system. Bleed the system without the pump running until both the hot and cold services run without any air.
B
Brandi GomezSep 3, 2025
How to fix flexible hose leaks on a Stuart Turner Water Pump?
- J
  John PerrySep 3, 2025
  If flexible hoses on your Stuart Turner Water Pump are leaking, first, make sure that the hose is firmly pushed onto the pump's inlet/outlet connections and the pipework. Also, check that the copper pipe ends are cleanly cut and deburred.
H
Heather BaileySep 10, 2025
Why is the flow reduced or intermittent in my Stuart Turner Water Pump?
- L
  leejamesSep 12, 2025
  Reduced or intermittent flow in your Stuart Turner Water Pump can stem from several causes. Begin by ensuring the anti-aeration flange is correctly installed according to the installation instructions. Verify that you're using the correct pipe sizes. Clean the inlet filters to remove any blockages. If the hot water temperature is too high, reduce the cylinder stat setting to a maximum of 65 degrees Celsius. Lastly, inspect and clean the showerhead spray plate, following the manufacturer's guidance.