4 EN/11.2018/G67C © STULZ GmbH – all rights reserved
wib8000 original instructions
1. Safety
IMPORTANT NOTE:
Some software versions have alterations in the file structure for parameter settings.
This was necessary to add new parameters.
New software versions are always capable of reading and interpreting older files of settings.
Older software versions can not read and interprete new files of settings.
Thus any downgrade (loading an older software than the currently loaded one) should be avoided
because it might lead to loss of settings.
Connection to the internet
The WIB8000 (Web Interface Board) may not be connected directly to the internet, but must be protected by
a firewall or a VPN tunnel.
So choose an IP address for the WIB from the private address ranges according to RFC 1918.
10.0.0.0 - 10.255.255.255
172.16.0.0 - 172.31.255.255
192.168.0.0 - 192.168.255.255
Find details for the IP address setting on page 15.
Settings
A password with administrator authorization for the first access is printed on the adhesive label.
Find details for the password setting on page 27.
NOTICE
All three passwords must be modified by the administrator during start-up (possibly
specifically for each WIB module) !
ESD NOTE
Notice the country specific ESD standards when opening the unit.
To Next Page
Loading...