Stulz WIB8000 - A6. Network Check List

50 EN/11.2018/G67C © STULZ GmbH – all rights reserved
wib8000 original instructions
A6. Network check list
1. General
Use DHCP: Yes (continue with item 2) No
IP address of the WIB: [___.___.___.___]
Subnet mask: [___.___.___.___]
Gateway: [___.___.___.___]
DNS server: [___.___.___.___]
2nd DNS server: [___.___.___.___] http port: ___
2. Access authorization
Modify password:
3. E-mail
SMTP server: ___.___.___.___
(IP address / server name) _______________ (max. 30 characters)
SMTP port: _____ (max. 5 numerals)
User: ____________________ (max. 64 characters)
____________________
Password (plain text): ____________________ (max. 64 characters)
____________________
Authentication *: None DIGESTMD5 CRAMMD5
LOGIN PLAIN AUTO
Sender: ____________________ (max. 64 characters)
____________________
4. SNMP - 1st part
Read community: _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ (max. 20 characters)
Write community: _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ (max. 20 characters)
Trap receiver 1
Community: _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ (max. 20 characters)
IP address/ server name: [ _ _ _ . _ _ _ . _ _ _ . _ _ _ ]
port: _ _ _ _ _ (max. 5 numerals)
Trap receiver 2
Community: _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ (max. 20 characters)
IP address/ server name: [ _ _ _ . _ _ _ . _ _ _ . _ _ _ ]
port: _ _ _ _ _ (max. 5 numerals)
* Setting "Auto" may result in authentication error if it is insufficiently implemented at the e-mail server.
In case of authentication errors with your e-mail account, ask your e-mail host provider which is the proper method and select this
method deliberately.