Stulz WIB8000 - Troubleshooting; SNMP Connection Issues

40 EN/11.2018/G67C © STULZ GmbH – all rights reserved
wib8000 original instructions
7. Troubleshooting
7.1 Problems with the connection via SNMP
1. Reachability

access by SNMP is set as "enabled". (see page 17)

function test of the connection.
OID:1.3.6.1.2.1.1.1.0  Stulz GmbH Klimatechnik WIB 8000 // sysDescr
OID:1.3.6.1.2.1.1.2.0  1.3.6.1.4.1.29492.10 // sysObjectID
OID:1.3.6.1.2.1.1.5.0  WIB 8000 SNMP Interface // sysName
OID:1.3.6.1.2.1.1.6.0  aircondition // sysLocation
2. Speed
bus configuration (Timeout, Cache holding time and Pre-fetch period) on page 19.
As many values do not change so often, you can set a bigger cache holding time.

than if it is connected with the C7000IOC and the A/C unit by an EBus board.


-
loaded from the EStulz area.