PAGE 99
700-3 SERIES - BASE UNITS
» Clearing Error Codes
1. Unit must be ON
2. Repair problem
3. Press and hold Bell ON/OFF key for 15 seconds
» Manual Component Activation Mode
(Energizes cooling system for 5 minutes)
1. Unit must be ON
2. Press desired
COLDER & UNIT ON/OFF keys simultane-
ously for 10 seconds
NOTE: After performing the above key strokes (depending on
COLDER key chosen), the following will appear on the LCD.
Temperatures shown are for reference only, actual temperatures
may vary.
--0055
SERVICE (Illuminated)
EE
Temperature of E (Evaporator)
OR
3366
SERVICE (Illuminated) r
Temperature of r (Refrigerator Compartment)