EasyManua.ls Logo

Sub-Zero 700-2 Series

Sub-Zero 700-2 Series
166 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Page 29
Electronic Control
Integrated (
Integrated (
700-
700-
2) Series
2) Series
3-19
#3756780 - Revision D - July, 2005
Figure 3-31. Model 700TC/I-2
“ICE” & “SERVICE” Flashing = Water Valve Solenoid energized 15 Seconds, Icemaker System Disabled
NOTE: To clear this error indicator the problem must be corrected, then the unit switched OFF and back ON.
UNIT
UNIT
ICE
ICE
WARMER
WARMER
COLDER
COLDER
REFRIGERATOR
REFRIGERATOR
ON/OFF
ON/OFF
ON/OFF
ON/OFF
ON/OFF
ON/OFF
WARMER
WARMER
COLDER
COLDER
FREEZER
FREEZER
SERVICE
SERVICE
Figure 3-29. Model 700TC/I-2
“EE” Displayed at Left and “SERVICE” Flashing = Freezer Compartment Thermistor (or its Wiring) Fault
NOTE: To clear this error indicator the problem must be corrected
UNIT
UNIT
ICE
ICE
WARMER
WARMER
COLDER
COLDER
REFRIGERATOR
REFRIGERATOR
ON/OFF
ON/OFF
ON/OFF
ON/OFF
ON/OFF
ON/OFF
WARMER
WARMER
COLDER
COLDER
FREEZER
FREEZER
SERVICE
SERVICE
Figure 3-30. Model 700TC/I-2
“EE” Displayed at Right and “SERVICE” Flashing = Refrig. Compartment Thermistor (or its Wiring) Fault
NOTE: To clear this error indicator the problem must be corrected
ICE
ICE
UNIT
UNIT
ICE
ICE
WARMER
WARMER
COLDER
COLDER
REFRIGERATOR
REFRIGERATOR
ON/OFF
ON/OFF
ON/OFF
ON/OFF
ON/OFF
ON/OFF
WARMER
WARMER
COLDER
COLDER
FREEZER
FREEZER
SERVICE
SERVICE
UNIT
UNIT
ICE
ICE
WARMER
WARMER
COLDER
COLDER
REFRIGERATOR
REFRIGERATOR
ON/OFF
ON/OFF
ON/OFF
ON/OFF
ON/OFF
ON/OFF
WARMER
WARMER
COLDER
COLDER
FREEZER
FREEZER
SERVICE
SERVICE
Figure 3-32. Model 700TC/I-2
“SERVICE” Alone Flashing = Excessive Compressor Run (OR) Refrig. Evap. Thermistor (or its Wiring) Fault
NOTE: To help identify the problem, Diagnostic Mode (Covered later in this section) should be initiated.
NOTE: To clear this error indicator the problem must be corrected, then the unit switched OFF and back ON.
POSSIBLE 700-2 TALL UNIT ERROR INDICATORS
The next few pages contain diagrams illustrating what a customer may see on the LCD if there is a problem/error
with the unit. Please note the serial number breaks listed under some diagrams.
For Model 700TC/I-2, See Figures 3-29 through 3-33
For Model 700TR-2, See Figures 3-34 through 3-37
For Model 700TF/I-2 and Model 700TF/I-2V, See Figures 3-38 through 3-41
UNITICE
REFRIGERATOR
ON/OFF
ON/OFF
ON/OFF
WARMERCOLDER
FREEZER
WARMERCOLDER
SERVICE
Figure 3-33. Model 700TC/I-2 (AFTER SERIAL #1759493)
“EC” at Right and “SERVICE” Flashing = Excessive Compressor Run with Error Codes Registered
NOTE: To clear this error indicator and error code, the problem must be corrected, then the alarm bell ON/OFF
key must be pressed and held for 15 seconds.

Related product manuals