Integrated Installation 20
90° door stop.
Dual Installations
T
wo integrated units may be placed side by side in a dual
installation. Panel width dimensions will vary slightly from
single installations. A dual installation kit is required for
installations with 2" (51) or less space between units.
Dual installation kits are available through your authorized
Sub-Zero dealer.
IMPORTANT NOTE: If a 27" (686) unit is installed next to a
36" (914) tall model, the decorative front panels will align,
however, the face frames will not. This is only apparent
when both doors are open at the same time. Due to a
more robust hinge on 36" (914) units, the face frame was
reconfigured to maintain a consistent overall panel height.
Typical Panel Dimensions
COLUMN MODELS WH
Door 26
13
/16" (681) 76
7
/8" (1953)
27" (
686)
MODELS WH
Door 26
13
/1
6
" (681) 45
3
/8" (1153)
Top Drawer 26
13
/1
6
" (681) 13
9
/1
6
" (345)
Bottom Drawer 26
13
/16" (681) 16
11
/16" (424)
36" (914) MODELS WH
Door 35
13
/16" (910) 45
3
/8" (1153)
Top Drawer 35
13
/16" (910) 13
9
/16" (345)
Bottom Drawer 35
13
/16" (910) 16
11
/16" (424)
90° Door Stop
T
he door of integrated columns and tall models opens
to 105°. A 90° door stop is built into the hinge system for
installations where the door opening must be limited.
To engage the door stop, use the blade edge of a
standard screwdriver and rotate the cam in the center
portion of the hinge. You must make this adjustment to
both the bottom and top hinge. Refer to the illustration
below.
To Next Page
Loading...
