Sub-Zero BI-42SD Use & Care Guide

Lighting Information
IMPORTANT NOTE: When a refrigerator or freezer door is
left open for a long time, the lights may go off. This
protects the internal parts from overheating. To reset the
light system, close the door for 15–30 minutes.
Your Sub-Zero built-in unit contains unique 40-watt
appliance bulbs in the refrigerator and freezer sections.
Built-In Use & Care 26
Shut off power at the control panel before changing
light bulbs. Wear protective gloves when handling
bulbs.
PEG
SLOT
Overhead lighting.
OVERHEAD LIGHTING
To replace the light bulbs, you will need to remove the
light diffuser in the top of the unit. Place your hands under
the light diffuser and slide back firmly, until the slots on
the sides of the diffuser drop past the bracket pegs. Lower
the light diffuser to remove. Refer to the illustration below.
To reinstall, align the slots of the light diffuser onto the
bracket pegs. Then pull forward fully so the tabs on the
slots engage the pegs on the bracket.
Models BI-36RG, BI-30UG and BI-36UG: Like all built-in
units, lights in glass door models will fully illuminate when
the door is open. With models BI-36RG, BI-30UG and
BI-36UG, however, you have the option of having subdued
lighting even with the door closed. You can easily turn this
feature off by pressing the LIGHT ON/OFF key pad on the
control panel. The indicator will appear when accent
lights are enabled.

Sub-Zero BI-42SD Specifications

General

Brand	Sub-Zero
Model	BI-42SD
Category	Refrigerator
Language	English