NOTES:
• The main control board is used in domestic and international units.
• When scrolling through model codes, please note that they do not appear in model numerical order.
• Follow instructions that accompany service control board as the codes do change according to serial number as
well as domestic vs. domestic models.
Electronic Control System
3-43
#7019014 - Revision A - October, 2010
Built-In (BI) Series
Built-In (BI) Series
Figure 3-82. Toggle Through Model Codes with Multiple Key Strokes of COLDER or WARMER keys
Until Correct Model Code is Displayed (“00” and “1” = 36” Over -Under)
PURE AIR WARMER COLDER WARMER COLDER ALARM POWER MAX ICE ICE MAKER LIGHTS
Figure 3-83. Stop When Correct Model Code is Displayed (“00” and “3” = 48” Side-by-Side)
PURE AIR WARMER COLDER WARMER COLDER ALARM POWER MAX ICE ICE MAKER LIGHTS
Figure 3-84. Press POWER Key when Correct Code is Displayed, “Pr” and “g” Appear on LCD
Asking if the Code Displayed Should be Programmed/Stored
PURE AIRWARMERCOLDER WARMERCOLDER ALARM POWERMAX ICEICE MAKERLIGHTS
Figure 3-85. Press POWER Key Again - Configuration is Complete,
Model Code is Displayed for 3 Seconds (“00” and “3” = 48” Side-by-Side), then Temperatures are Displayed
PURE AIR WARMER COLDER WARMER COLDER ALARM POWER MAX ICE ICE MAKER LIGHTS
To Next Page
Loading...
