10
|
Cove Customer Care 800.222.7820
INSTALLATION
Installation
COMPLETION
1 Turn the water and electrical supply on.
2 For water softener models, refer to the Water Softener
section to adjust the water hardness, then proceed to
the next step.
3 Install all interior racks.
4 Run a Quick cycle and check for leaks.
Water Softener
For water softener models only, a salt compartment is
located at the bottom of the interior. Refer to the illustration
below. Softener salt is available through an authorized Cove
dealer.
Prior to lling the salt compartment for the rst time, ll the
compartment with water. Water does not have to be added
with subsequent rells.
To add softener salt:
1 Pull the lower rack forward and if necessary, turn the
lower spray arm away from the compartment cover.
2 Turn the cover counterclockwise to remove. It is normal
for the reservoir to contain water.
3 Fill the compartment completely with dishwasher soft-
ener salt.
4 Once full, clean any excess salt from the threads of
the salt compartment, then turn the cover clockwise to
secure.
Softener salt compartment
To Next Page
Loading...
Need help?
General