BAJA U.S.A..A2310BE–A
2
Keys and doors
2-15
– CONTINUED –
n To arm the system using power door locking switches
HB2024CC
1. Close all windows and the moonroof.
2. Remove the key from the ignition switch.
3. Open the doors and get out of the vehicle.
4. Make sure that the engine hood and switchback door are locked.
5. Close the doors but leave only the driver’s door or the front pas-
senger’s door open.
6. Push the power door locking switch forward (“LOCK” side) to set
the door locks.
7. Close the door. An electronic chirp will sound one time, the turn
signal lights will flash one time and the indicator light will start flashing
slowly (approximately once every two seconds) to inform you that the
system has armed.
NOTE
The system can be armed even if the engine hood, the windows,
the switchback door and/or moonroof are open. Always make
sure that they are fully closed before arming the system.
B Disarming the system
Briefly press the “UNLOCK/DISARM” button (for less than two
seconds) on the remote transmitter. The driver’s door will unlock, an
electronic chirp will sound two times, the turn signal lights will flash
two times and the indicator light will go off.
To unlock all other doors, briefly press the “UNLOCK/DISARM” button
To Next Page
Loading...
