BAJA U.S.A..A2310BE–A
6
Interior and exterior equipments
6-23
– CONTINUED –
HB6038BA
As you insert (and pull) the soft portion of the bed cover into the bed
cover’s hard section, make sure the next 10 to 15 inches (250 to 380
mm) of the soft portion are straight and ready to enter the flared out
portion of the hard section.
Once you have pulled the soft portion of the bed cover onto the bed
cover’s hard section, make sure the soft portion is equally centered on
both sides. To complete the installation, refer to “Securing the cover”.
Roof rail and crossbar
CAUTION
D For cargo carrying purposes, the roof rail must be used to-
gether with a roof crossbar kit and the appropriate carrying at-
tachment. The roof rail must never be used alone to carry cargo.
Otherwise, damage to the roof or paint or a dangerous road haz-
ard due to loss of cargo could result.
D When using the roof crossbar kit, make sure that the total
weight of the crossbars, carrying attachment and cargo does not
exceed the maximum load limit. Overloading may cause damage
to the vehicle and create a safety hazard.
To Next Page