BAJA U.S.A..A2310BE–A
9-12
HGS038BA
4. Put wheel blocks at the front and rear of the tire diagonally opposite
the flat tire.
5. Take out the spare tire, jack, and wheel nut wrench.
Refer to the sections “Spare tire” and “Jack and tools” in this chapter for
their location, instructions and precautions.
After the spare tire is removed from the spare tire holder, the cable must
be wound up completely by turning the hoist nut shaft clockwise until
you hear a clicking sound. Also visually inspect the cable to make cer-
tain that there is no longer any slack present.
B Removing the flat tire and installing the spare tire
HS9008BA
1. Loosen the wheel nuts using the wheel nut wrench but do not re-
move the nuts.
To Next Page
Loading...
