Subaru 2007 Forester - License Plate Light; Dome Light and Map Light

11-48 Maintenance and service
1) Tail/stop light
2) Backup light
3) Rear turn signal light
4) Tail/stop light
2. Remove the bulb holder from the rear
combination light assembly by turning it
counterclockwise.
3. Pull the bulb from the holder. Install a
new bulb.
4. Set the bulb holder into the rear combi-
nation light assembly and turn it clockwise
until it locks.
5. Reinstall the rear combination light as-
sembly.
 License plate light
0
1. Remove the mounting screws using a
Phillips screwdriver.
2. Remove the cover and lens.
3. Pull the bulb out of the socket. Install a
new bulb.
4. Reinstall the lens and cover.
5. Tighten the mounting screws.
 Dome light and map light
Dome light
Map light
1. Remove the lens by prying the edge of
1
2
3
4
B00390
B00391 B00090
B00091
A8110BE.book 48 ページ ２００６年６月２３日 金曜日 午後１時３２分