What causes noise when automatic braking control activates in my Subaru?
The sound you hear is the normal operation of the automatic braking control. The system has mechanical components that may make audible sounds during automatic braking control. This does not indicate a malfunction.
What to do if Adaptive Cruise Control cannot be set in Subaru EyeSight?
First, ensure that you have pressed the (CRUISE) switch; the (Adaptive Cruise Control indicator) will not appear if you haven't. Next, check if EyeSight operation is temporarily stopped, indicated by the (EyeSight temporary stop indicator). If so, resolve the cause of the stop and then try setting Adaptive Cruise Control again. Finally, confirm that the (READY indicator) is displayed, as Adaptive Cruise Control cannot be set without it.
Why is my Subaru EyeSight Automobile Accessories Lane Keep Assist unexpectedly canceled?
Lane Keep Assist may be temporarily canceled if the system cannot detect steering operation, which can happen if you take your hands off the steering wheel or only lightly touch it. Also, Lane Keep Assist does not operate while turning a tight corner.
What to do if a noise occurs when automatic braking control activates in Subaru EyeSight?
The noise you hear is the normal sound of the automatic braking control operating. The system has mechanical components that may make audible sounds during automatic braking. This does not indicate a malfunction.
What to do if the engine does not restart in my Subaru?
If the Auto Start Stop warning indicator illuminates, shift the select lever to the P position and start the engine with the brake pedal depressed. If the warning light does not turn off after the engine starts, immediately contact a SUBARU dealer to have the system inspected.
Why is not displayed on my Subaru EyeSight Automobile Accessories?
The symbol in your Subaru Automobile Accessories will not be displayed if the requirements for setting cruise control are not met. These requirements include: the brake pedal is depressed, the vehicle speed is over 90 MPH (145 km/h), the combination meter indicates a position other than D (select lever or paddle shift switches are manually operated), the driver’s seatbelt is unfastened, any door is opened (except the rear gate/trunk), the vehicle is on a steep grade, the steering wheel is turned significantly, or the parking brake is released.
Why is my Subaru Adaptive Cruise Control braking frequently in heavy traffic?
When Adaptive Cruise Control is activated, the EyeSight system controls the car based on the movement of vehicles or objects in front. As a result, acceleration and deceleration may be more frequent while the system adjusts to vehicles or objects the camera system is detecting. If maintaining a consistent following distance is difficult under certain conditions (such as in heavy traffic, poor weather, or urban environments), it is advised not to use Adaptive Cruise Control.
Why does the 'brake more' warning timing vary in my Subaru EyeSight Automobile Accessories?
The “brake more” warning in your Subaru Automobile Accessories activates when the system determines that more braking is necessary, based on factors like the distance from the vehicle in front and the speed difference. The timing of the warning can vary depending on how the brakes are applied relative to the vehicle in front and your speed relative to that vehicle.
Why does Lane Keep Assist not operate even though there are lane markers for Subaru EyeSight?
To operate Lane Keep Assist, the width of the road should be between approximately 10 ft (3 m) and 15 ft (4.5 m).
Why does my Subaru EyeSight Automobile Accessories make a noise when automatic braking activates?
The automatic braking control in your Subaru Automobile Accessories has mechanical components that may produce audible sounds during operation. This sound does not necessarily indicate a malfunction.
General| Type | Driver Assist Technology |
|---|---|
| Camera System | Stereo Camera |
| Additional Functions | Adaptive Cruise Control, Lane Keep Assist |
| Detection Range | Up to 110 meters |
| System Activation | Automatic upon vehicle start |
| Availability | Standard or Optional on most Subaru models |
To Next Page
