About EyeSight
19
■ (CRUISE) switch
• Switches cruise control
*
on/off.
• When the
(CRUISE) switch is pressed, “ ” appears on the EyeSight display
area in the combination meter display, and then
appears by pressing and holding
the (following distance setting) switch for approximately 2 seconds. When “ ” or
“ ” is shown on the EyeSight display, this indicates that the main cruise control is on.
⇒ Refer to pages 42 and 79.
• This switch can be used to cancel the cruise control.
⇒ Refer to pages 50 and 84.
* Adaptive Cruise Control and Conventional Cruise Control
■ RES/SET switch
●
SET/-
• This switch can be used to set cruise control
*
.
• This switch can be used to reduce the set vehicle speed (when cruise control
*
is currently
set).
⇒ Refer to pages 43 and 47 (for Adaptive Cruise Control).
⇒ Refer to pages 81 and 83 (for Conventional Cruise Control).
* Adaptive Cruise Control and Conventional Cruise Control
●RES/+
• After cruise control
*
is canceled, this switch can be used to resume the cruise control
function at the vehicle speed that was previously set.
• This switch can be used to increase set vehicle speed (when cruise control
*
is currently
set).
⇒ Refer to pages 46 and 53 (for Adaptive Cruise Control).
⇒ Refer to page 87 (for Conventional Cruise Control).
* Adaptive Cruise Control and Conventional Cruise Control
■ (Following distance setting) switch
• This switch can be used to switch the set following distance in 3 stages: (only when Adap-
tive Cruise Control is on).
⇒ Refer to page 49.
• When the (CRUISE) switch is on, switching between Adaptive Cruise Control and
Conventional Cruise Control is possible by pressing the (Following distance setting)
switch*.
* To switch to Conventional Cruise Control, press and hold the switch for approximately 2
seconds or longer.
B8232BE-A.book 19 ページ ２０１７年３月９日 木曜日 午前１１時４分
To Next Page
Loading...
