98
Troubleshooting
Adaptive Cruise Control cannot be set.
Did you remember to press the (CRUISE) switch?
If you have not pressed the (CRUISE) switch, (Adaptive Cruise
Control) will not be shown.
Is EyeSight operation temporarily stopped?
When EyeSight is temporarily stopped, is displayed on the combination
meter display.
Set Adaptive Cruise Control again after the cause for the temporary stop has been
corrected.
Is displayed?
Adaptive Cruise Control cannot be set when is not displayed. Set Adaptive
Cruise Control when is displayed.
is not displayed.
Has Conventional Cruise Control turned on?
When the Conventional Cruise Control function has turned on, the “READY” indi-
cator does not illuminate in the EyeSight display area on the combination meter
display.
Are the requirements for setting cruise control met?
In any of the following cases, will not be displayed.
• The brake pedal is depressed.
• The vehicle speed is over 90 MPH (145 km/h).
• The combination meter indicates a position other than . (The select
lever or paddle shift switches are manually operated.)
• The driver’s seatbelt is unfastened.
• Any door is opened (except the rear gate/trunk).
• The vehicle is on a steep grade.
• The steering wheel is turned significantly in either direction.
• Parking brake is applied.
• The X-mode is turned on (the X-mode indicator light illuminates).
• The EyeSight system is stopped temporarily.
D
B8232BE-A.book 98 ページ ２０１７年３月９日 木曜日 午前１１時４分
To Next Page
Loading...
