90
EyeSight malfunction and temporary stop
If a malfunction is detected in the EyeSight system, the indicators in the instrument panel
and the combination meter display inform the driver of the malfunction. Check the displayed
contents and take the appropriate action.
■ Malfunction (including position/angle misalignment of stereo
camera)
The buzzer sounds 1 short beep and the
EyeSight warning indicator (yellow)
flashes or illuminates. At the same time, the
Pre-Collision Braking System OFF indicator
light and the Lane Departure Warning OFF
indicator light will illuminate. A message will
also be displayed on the combination meter
display.
Displayed screen Cause Action
An EyeSight malfunction or
position/angle misalignment
of stereo camera has
occurred.
Inspection and adjustment is
necessary.
Contact your SUBARU
dealer.
CAUTION
If both the EyeSight warning indicator and the CHECK ENGINE warning
light/malfunction indicator light illuminate at the same time while driving, have
your vehicle checked/repaired by a SUBARU dealer as soon as possible.
EyeSight cannot be used if there is an abnormality with the engine, etc.
NOTE
• If the EyeSight warning indicator is illuminating or flashing, stop the vehicle
in a safe location, turn off the engine and then restart it.
• If the EyeSight warning indicator illuminates or flashes, the RAB system
may not operate (models equipped with RAB).
• If the indicator continues illuminating or flashing even after the engine has
been restarted, the EyeSight system has a malfunction. In this case, all
EyeSight functions will be stopped. Normal driving will still be possible.
However, contact a SUBARU dealer for an inspection.
S02145
S00699
B8232BE-A.book 90 ページ ２０１７年３月９日 木曜日 午前１１時４分
To Next Page
Loading...
