Adaptive Cruise Control
42
Adaptive Cruise Control is available when the engine is turned on.
■ Setting Adaptive Cruise Control
(1) Setting Adaptive Cruise Control to standby status
Press the (CRUISE) switch. At this time, “ ” (Adaptive Cruise Control), your vehi-
cle indicator and the following distance setting indicator are displayed on the EyeSight dis-
play area in the combination meter display.
The set vehicle speed display will read “- - MPH”.
If the switch is pressed once more, the EyeSight display will turn off. It will also automatically
turn off when the engine is stopped.
To set ready status:
Adaptive Cruise Control can be set when all
of the following conditions are met and
is displayed on the EyeSight display area.
- All doors (except the rear gate/trunk) are
closed.
- The driver’s seatbelt is fastened.
- The select lever is in the position and
the paddle shift is not operated.
- The brake pedal is not depressed.
- EyeSight operation is not temporarily
stopped.
⇒ Refer to page 91.
- The road is not a steep slope.
- X-mode is not turned on.
- The steering wheel has not been turned significantly in either direction.
- The vehicle speed is between approximately 0 MPH (0 km/h) and 90 MPH (145 km/h).
- Parking brake is released.
How to use Adaptive Cruise Control
S02083
S01333
S01334
D
B8232BE-A.book 42 ページ ２０１７年３月９日 木曜日 午前１１時４分
To Next Page