Conventional Cruise Control
79
Conventional Cruise Control can be set when the following conditions are met.
- The select lever is in the position and the paddle shift is not operated.
- The brake pedal is released.
- The vehicle speed is between approximately 25 MPH (40 km/h) and 90 MPH (145
km/h).
- Parking brake is released.
■ Setting Conventional Cruise Control
(1) Setting the Conventional Cruise Control to standby status.
Press the (CRUISE) switch. At this time, (Adaptive Cruise Control) and the
following distance setting indicator are displayed on the EyeSight display area of the
combination meter display. The set vehicle speed display will read “- - MPH”.
When the (CRUISE) switch is pressed, the initial cruise control mode is always
Adaptive Cruise Control.
If the (CRUISE) switch is pressed once more, the EyeSight display will turn off. It will
also automatically turn off when the engine is stopped.
How to use the Conventional Cruise Control
D
S02083
S01333
B8232BE-A.book 79 ページ ２０１７年３月９日 木曜日 午前１１時４分
To Next Page
Loading...
