Conventional Cruise Control
85
●Automatic cancellation by the system
In the following cases, a buzzer sounds a single long beep and the Cruise control function is
automatically canceled ( is displayed on the EyeSight display area.). After the condi-
tions listed below have been resolved, perform the cruise control set operation again to
reactivate cruise control.
• The select lever was moved to a position other than .
The cruise control function can be used again after the lever is returned to the posi-
tion.
• A paddle shift switch was operated during
driving with the lever in the position.
The cruise control function can be used
again after the shift indicator returns to .
• Vehicle speed drops to approximately 20
MPH (30 km/h) or less (due to a steep uphill
grade or some other reason).
• Vehicle speed increases to approximately 100 MPH (160 km/h) or more.
• The Vehicle Dynamics Control or Traction Control Function is activated.
• Any door (except the rear gate/trunk) was opened.
• The driver’s seatbelt is unfastened.
• EyeSight is malfunctioning. (Refer to page 90, “EyeSight malfunction and temporary
stop”.)
• The steering wheel is turned significantly in either direction.
• The grade of the road is steep.
• The Pre-Collision secondary braking has activated.
• Parking brake is applied.
WARNING
Do not use Conventional Cruise Control on slippery roads. Doing so may
result in an accident.
D
D
S02685
D
D
OFF indicator
B8232BE-A.book 85 ページ ２０１７年３月９日 木曜日 午前１１時４分
To Next Page