Conventional Cruise Control
87
■ Resuming a vehicle speed that was previously stored
A vehicle speed that has been previously set is stored in memory
*
. To recall and set that
vehicle speed, press the RES/SET switch to the “RES/+”. (The EyeSight display area shows
the set condition again.)
Resume is possible when a vehicle speed was previously set, and the current vehicle speed
is approximately 20 MPH (30 km/h) or more.
NOTE
* The vehicle speed stored in memory is erased in the following
circumstances:
- The cruise control is turned off by pressing the (CRUISE) switch.
- Either vehicle Dynamics Control or Traction Control Function has been
activated.
- The cruise control mode was switched from Conventional Cruise Control
to Adaptive Cruise Control.
• The vehicle drives constantly and correspondingly to the set vehicle speed
between 25 MPH (40 km/h) and 90 MPH (145 km/h).
• If there is no vehicle speed in the memory (a previously set vehicle speed),
the vehicle speed cannot be resumed by depressing the RES/+ switch.
S02086
S02684
SET indicator
B8232BE-A.book 87 ページ ２０１７年３月９日 木曜日 午前１１時４分
To Next Page