ROUTE GUIDANCE
234
No. Function
Select to create a new route at the position you
selected. Previous destinations and waypoints are
deleted.
Select to add the position you selected as a new
waypoint for the current route. Other destinations for
the route are already enabled. Note: Waypoints are
set so that the optimum route is maintained between
destinations. You can use the route editing function to
set the position for waypoints on the route.
6HOHFWWRDGGWKHGHVWLQDWLRQ\RXVHOHFWHGDVWKH¿QDO
destination for the current route. Other destinations for
the route are already enabled. Up to now, the position
PDUNHGDVWKH¿QDOGHVWLQDWLRQEHFRPHVWKH¿QDO
waypoint.
SETTING A NEW STARTING POINT
In standard navigation, all routes are created from the
current position. You can turn off the GPS so that you
can study a route that is not currently being driven, run a
simulation, and check the time or distance for the route. This
way, you can set a start point for the route without using the
current GPS position.
1. Display the “Change Route (Change Route)” screen.
ĺ3
2. Select
Edit Route
(Edit Route) /
Create Route
(Create Route).
Ɣ
Edit Route
(Edit Route) is displayed only when
a route is set.
Create Route
(Create Route) is
displayed when a route is not set.
3. Select , if a warning message is displayed, select
which operation to perform.
To Next Page
General
