What to do if the sound suddenly stops working in my Subaru Outback 2020 Automobile?
If the sound suddenly stops working in your Subaru Automobile, it may be due to an error in the system. In this case, reset the system.
Why SUBARU STARLINK does not start in my Subaru Outback 2020 Automobile?
If SUBARU STARLINK does not start in your Subaru Automobile, it could be due to the time not matching. Connect your smartphone. Alternatively, set the phonebook download function to on.
What to do if 'Connection failed. Unable to check for updates because no active internet connection has been detected' is displayed on my Subaru Automobile?
If you see the message “Connection failed. Unable to check for updates because no active internet connection has been detected.” in your Subaru Automobile, it means that the connection between the system and the Wi-Fi access point is weak or has been lost. To resolve this, connect the system to the Wi-Fi access point again and perform the update in an area with low electrical noise.
Why can't I view messages on my Subaru Outback 2020?
If messages cannot be viewed on your Subaru Automobile, it is likely that message transfer is not enabled on your cellular phone. To fix this, enable message transfer on your cellular phone (approve message transfer on the phone).
How to fix weak Wi-Fi connection in my Subaru Outback 2020 Automobile?
If the connection between the system and the Wi-Fi access point is weak or has been lost in your Subaru Automobile, connect the system to the Wi-Fi access point again and perform the update in an area with low electrical noise.
What does 'Installation Failed (1)' mean on my Subaru Outback 2020?
If you see “Installation Failed (1)” on your Subaru Automobile, it means the reading of the data on the USB memory device failed. Disconnect and then reconnect the USB memory device, check that it is connected correctly, and attempt to perform the update again.
What does 'Installation Failed (2)' mean on my Subaru Outback 2020?
If you see “Installation Failed (2)” on your Subaru Automobile, it indicates that corruption of the data on the USB memory device was detected. To resolve this, download the map update data again, copy it to a different USB memory device, and attempt to perform the update again.
What does 'Installation Failed (5)' mean on my Subaru Outback 2020?
If your Subaru Automobile displays “Installation Failed (5)”, it means that an error in the system data was detected while performing the update. Download the map update data again, copy it to a different USB memory device, and attempt to perform the update again.
General| Brand | Subaru |
|---|---|
| Model | Outback 2020 |
| Category | Automobile |
| Language | English |
To Next Page