Subaru Outback 2021 - Page 89

11. Select (Download Now) to begin
downloading the update (if available).
●
Cancel
(Cancel): Select to stop the update process.
● The do
wnload status progress is displayed in the
category area.
● If the update procedure fails, refer to the
“TROUBLESHOOTING” section. (→P.238)
*
1
: 11.6-inch display with Navi system
*
2
: 11.6-inch display system with SUBARU STARLINK Safety and Security
*
3
: 11.6-inch display system without SUBARU STARLINK Safety and Security
UPDATE INSTALLATION
CAUTION
l Park your vehicle in a safe place when installing the update.
l The following system functions are restricted during the update
installation.
• It will not be possible to use general system functions.
• Only the rear view camera image will be displayed. Or the
image will disappear temporarily.
1. Download any available updates.
2. Select (Install Now) to start installing the
update.
● Installa
tion will take several minutes.
NOTE
l During software update installation, the screen may icker. However,
this is not a malfunction.
3. When installation is complete, select
OK
(OK) on the
conrmation message to complete the update process.
● If the upda
te procedure fails, refer to the
“TROUBLESHOOTING” section. (→P.238)
4. Turn the ignition switch to the “LOCK”/“OFF” position →
Open the driver’s side door → Close the door → Wait for 3
minutes or more → Start the engine.
● The new software will be applied.
OTHER SETTINGS
89
Settings
3
GB8_US.indb 89 2020/10/09 7:22:37