Model UC-15I (Undercounter Ice Machine)
Installation Information
2-11
#7012423 - Revision B - May, 2011
DOOR PANEL INSTALLATION
Be sure of the door panel size and placement before
proceeding with the installation. If there are questions,
contact the Sub-Zero dealer or cabinet supplier.
Instructions regarding sizing of the door panel are pro-
vided in the Sub-Zero design guide.
For door handle hardware, a D-style pull centered on
the edge opposite the door hinge side is recommended.
Screw heads may have to be countersunk to ensure
that the hardware does not interfere with the panel fit-
ting flush with the unit door.
DOOR PANEL DIMENSIONS
Door Panel Width – 1/8” (3) reveal 15” (381)
Door Panel Height – 1/8” (3) reveal
4” (102) toe space 30-3/8” (772)
Door Panel Thickness 5/8” (16) min
Door Panel Weight 15 lbs (6.8 kg) max
Dimensions may vary +_ 1/8” (3).
PANEL DESIGN NOTE: Additional panel design infor-
mation can be found in the Sub-Zero design guide.
Check our website at subzero.com.
Panel Preparation and Installation
1. Remove the handle side bracket attached to the
front of the door and set aside.
2. Place the door panel lying face down on a protect-
ed surface to ensure the front is not scratched or
damaged.
3. Position the template provided flush with the upper
edge of the panel. Be sure to follow the exact loca-
tion for the RH or LH door position. Refer to the
illustration below.
NOTE The door panel is being viewed from the back
side in the illustration. The overall size of the panel
shown is the minimum size necessary to cover the door
of the unit. The exact measurements of the door panel
may vary depending on the particular installation being
followed.
4. Once the proper position for the hardware has been
located, mark the holes, remove template, and drill
pilot holes for mounting of the hardware.
NOTE: It is recommended to start the first few holes,
positioning the hardware, drilling remaining pilot holes,
and securing the mounting brackets with the #8 x 1/2”
screws. Refer to the illustrations below.
5. Install the panel onto door by engaging the tabbed
bracket to the door first and then sliding the hinge
side hardware over the positioning screws. There
will be will have a 1/4" inch adjustment, up and
down, side to side, with this hardware.
6. Once the panel is in place, attach the remaining #8
x 1/2" screws to the hinge side mounting bracket
and install decorative caps.
To Next Page
Loading...
Need help?
General
