7.3 COMPRESSOR, FRAME AND DRIVE (CONTINUED)
Key Description Part Number Note Quantity
32 capscrew,hex 8.8 m12 x 40mm 828012–040 4
33 capscrew,hex 8.8 m12 x 75mm 828012–075 3
34 screw, socket iso 4762 m6 x 10mm 829306–010 1
35 screw, socket iso 4762 m8 x 16mm 829308–016 4
36 screw, socket iso 4762 m8 x 20mm 829308–020 3
37 screw, socket iso 4762 m8 x 30mm 829308–030 5
38 screw, socket iso 4762 m8 x 60mm 829308–060 3
39 screw, socket iso 4762 m8 x 80mm 829308–080 2
40 washer, spr lock–metric pltd m12 838812–250 3
41 washer, metric–iso7089– 8 865408–170 3
42 pin,dowel iso 8735 10x28–a–st 865510–028 1
43 pin,dowel iso 8735 10x70–a–st 865510–070 2
44 washer, iso 7093–12–140hv 865712–370 8
45 screw, set soc iso 4029 m12 x 12mm 865812–012 3
46 elbow, pipe 90 deg plt 1/2" 866215–020 1
47 nipple,pipe–xs plt 1/2 x 2 1/2 866408–025 1
48 plug,metric thd orng holhx m18 882018–015 1
49 nut,hex metric m12 x 1.75 882112–175 5
50 screw, hex serr washer m8 x 25 882608–025 6
A1 Tray Drain
(I) Sullair offers an exchange program whereby a remanufactured compressor unit can be obtained from Sullair distributors
or the factory at a lower cost than it would cost for the owner to repair the unit. For information regarding the unit exchange
program, contact your nearest Sullair representative or the Sullair Corporation.
The shaft seal is not considered part of the compressor unit in regard to the two year warranty, but the normal Sullair parts
warranty does apply. For shaft seal repairs, order wear sleeve replacement tool kit, P/N 02250167–507, repair kit P/N
02250061–961 and installation kit P/N 001932–005.
(II) This part may vary per machine specification. Consult the Sullair factory for details.
(III) For maintenance on minimum pressure valve group No. 02250046–338, order repair kit P/N 02250050–612.
PARTS LISTS
®SULLAIR®
1100e, 1500e, 1800e Operator’s Manual and Parts List
53
To Next Page
Loading...
