5.8 DEW POINT SENSOR SETUP SCREEN
● The Dew Point Sensor Setup button takes the controller to the Dew Point Sensor Set up screen.
Where the dew point sensor operating range is set. This is set at the factory and should not be
changed.
(Figure 5.8C)
● Hour meter readings are displayed on the OE Setup screen. The Machine Run Meter is the
same meter shown on the Service-Main Screen and it is the lifetime run hours meter. The
Energy Savings Meter is a lifetime hour meter that the dryer is in energy savings mode.
Neither of these hour meters can be reset in the field. (Figure 5.8A)
● Trend Sample Hours is used to set how often the dew point trend graph takes a reading.
This can be set from 1 hour up to 24 hours. The Trend Data Clear button clears the dew
point trend graphs.
● Pressing the Menu button will take the controller back to the Menu screen. (Figure 5.8B)
To Next Page
Loading...
